handbrake cable

Post by **camper2** » 17 Jan 2008, 23:16

hi all does anybody know if you have to drop the petrol tank to replace the front handbrake cable would be a lot of hassel just to renew a cable,steve

Post by **VWCamperfan** » 17 Jan 2008, 23:29

No I dont think you have to but I would probably join the new cable onto whatever remains of the old one with a connecting block of suitable size and pull it through, a lot easier that way!

Grumpy Midget · Post by **Grumpy Midget** » 18 Jan 2008, 00:15

Unfortunately Mr camper 2 you will have to drop your tank to replace the metaled rod which attaches to your handbrake lever, cannot be forced or dragged out as previously suggested, the rod has a rubber sleeve which is shaped half round with a collar on one end which locates into a shaped bracket where the rubber sleave clips in, to hold it up against the underside of van floor also to stop the rod flaying about, bit of a pain to fit into handbrake lever, but can be done with patience,Replaced mine during my conversion as mine snapped off at adjusting end, and I had fiited a temporary cure, if yours has broken off at adjuster end you can repair it with a 10mm threaded long sleeve nut, screw sleeve onto rod end with thread lock. screw snapped end into sleeve and put a lock nut on. this will do as a temporary repair,

-

Post by **Hacksawbob** » 18 Jan 2008, 07:18

VW fitted tank after hanbrake cable.

Post by **camper2** » 18 Jan 2008, 11:17

hi thanks guys looks like a bloody tank down job thanks for the tip about a ten mm long nut trouble with that is you could only ajust up the rear cables as far as the sleave my not be enough to tighten handbrake,steve

Grumpy Midget · Post by **Grumpy Midget** » 18 Jan 2008, 21:43

Forgot to mention you withdraw the handbrake rod by pulling it towards the back of the van after uncupling from the handbrake lever, when your lying on your back under the van???????