heaters

Post by **jigs** » 13 Dec 2007, 20:33

problem with my heaters in my 25 they resistor that controls the speed of the motor is missin so it only works on setting 3, need to find the values of the resistors to replace. any one help me out??

cheers

Post by **tonytech** » 13 Dec 2007, 21:11

I dont know the value of the resistor pack, but would hazard a guess at about 3ohms.
either make your own winding resistance wire on a (fire proof) former, or buy them ( probably need to be at least 5Watt)

Have you tested the switch?

T

Post by **jigs** » 13 Dec 2007, 22:00

yeah the switch is working fine just that 2 of the wires dont go anywhere! and according to the wiring diagram there should be a resistor but its missin