insulation

Thin bits of metal and bright blue light.

Moderators: User administrators, Moderators

Locked
meggles
Registered user
Posts: 11503
Joined: 16 Jun 2007, 22:04

insulation

Post by meggles »

Just wondering if I can use "Bondafoam" or similar on my van for insulation. It's the stuff you get in an aerosol for filling cavity walls as an insulation/filler. I was thinking of fitting my high top and than filling the gap down the curve of the roof and then levelling off with a sharp knife or saw before ply lining the upstairs "floor" area. Also thought it might work for behind side panels. Anyone tried it? Is it going to cause corrosion problems? Anyone know if it's a no no!. Appreciate responses, thanks.

DiscoDave
Registered user
Posts: 3651
Joined: 07 Oct 2005, 21:25
80-90 Mem No: 684
Location: Harrogate North Yorkshire.
Contact:

Post by DiscoDave »

i tried this for insulation and noise reduction in the front doors, not really seure if it worked but it made a mess!! quite a good idea to fill the gaps down the sides in the roof, but it does mean you loose a bit of storage, not a lot but it is good for putting long things like cb aerials and flag poles, also for small stuff you don't want to loose!

meggles
Registered user
Posts: 11503
Joined: 16 Jun 2007, 22:04

roof

Post by meggles »

I meant just filling the front and rear bits so you had a flat surface to sit bed/storage boards on. This would mean the bits just above drivers right shoulder and passengers left shoulder, then same again at rear. Then cut horizontally across to level of old cab roofline, if you see what I mean :? . The possibility of corrosion is what worries me.

guz
Registered user
Posts: 2048
Joined: 11 Oct 2005, 20:19
80-90 Mem No: 1762
Location: Nottingham, NG14 6PE.

Post by guz »

vw used similar stuff in the base of the C pillar
on some bugs, which is why you get a strange
patch of rust behind the back window,
tbh i wouldn't use owt like it.

mud
Registered user
Posts: 26
Joined: 02 Feb 2007, 00:14
80-90 Mem No: 883
Location: Wiltshire

Post by mud »

I know it is the best solution for insulating narrowboats because it sticks to the metal and leaves no gap for condensation, therefore no rust!

It's really messy and you will have to trim it back with an old breadknife but I reckon it's a good product. Just make sure the metal is cleaned to remove any surface rust/grease etc first.
"Boldly Going Nowhere"

colinMSC
Registered user
Posts: 67
Joined: 13 Jan 2007, 16:30
80-90 Mem No: 1544
Location: barrow cumbria

Post by colinMSC »

one word of warning . it is pritty toxic stuff whilst curing .
you should not breath the vapours in somthing to do with sionide i think.
so be carefull because it can litraly kill you. :shock:

meggles
Registered user
Posts: 11503
Joined: 16 Jun 2007, 22:04

fumes

Post by meggles »

Thanks for that, since health problems I have been over cautious, definately wear an appropriate mask!!!

thanks for warning though.

Locked