Should i have a large hole?

Post by **R0B** » 04 Jul 2007, 20:22

hmmm..c reg was 01 August 1985/31 July 1986.so i doubt very much it was an Aircooled.iirc the air cooled was made upto 84.does it look like a new front panel has been fitted at any point...

Post by **budbombpipe** » 04 Jul 2007, 21:21

It doesn't look obvious that the panel has been replaced, but i surpose it could of been done well. Just can't see why someone would go to the trouble of fitting an Aircooled panel on a watercooler. The lower grill that was covering the panel went from indicater to indicater (South African??)

Post by **R0B** » 04 Jul 2007, 21:34

neither can i.tis all very strange....

Just can't see why someone would go to the trouble of fitting an Aircooled panel on a watercooler

Post by **kevtherev** » 04 Jul 2007, 21:42

maybe it was fitted for the same reasons I would ......aesthetics!

Post by **R0B** » 04 Jul 2007, 21:48

but it should have a hole...

Post by **kevtherev** » 04 Jul 2007, 21:54

With the SA grill it shouldn't be much of a bother to create one eh?

Post by **R0B** » 04 Jul 2007, 21:58

should be no problem at all.but why it isnt there to begin with is very odd.to say the least.

With the SA grill it shouldn't be much of a bother to create one eh?

Post by **Mocki** » 06 Jul 2007, 12:42

seeings as the rad is colled in main by the lower grill, it would not be a clever idea to block it off.......... i suspect that the original poster has overheating isuues........

Post by **dridgy** » 07 Jul 2007, 07:10

did it overheat?

id be intersted to know as i was also thinking of blocking it off like kev.

it looks so much nicer without that horrible grill.

Club 80-90 Forums

Should i have a large hole?

plop