studs

Post by **NOT ANOTHER LEAK** » 19 Dec 2005, 17:33

after reading a posting by ashman about leaks on a dg engine.does any one know,if the studs snap when you take the cylinder head off is it defo a new engine or can you get the studs out and replace them

Post by **T'Onion** » 19 Dec 2005, 17:43

all depends on where the stud/s snaps

Post by **Hacksawbob** » 19 Dec 2005, 18:31

I think they can be drilled out and replaced, surely someone manufactures aftermarket stainless ones?

Post by **DiscoDave** » 19 Dec 2005, 21:05

yo can get the studs out sometimes easily some time not so. some reckon it's and engine out job it it/they snap but ive seen them done in situ!!

Post by **NOT ANOTHER LEAK** » 19 Dec 2005, 22:24

djb,i knew i should have changed the subject title