Door seal

Post by **joneseymagic** » 29 Apr 2007, 23:09

Any tips on fitting the sliding door seal on a t25?

I don't really want to take the door off, so it means cutting the seal at some point. Where's the best place to make the cut - I suspect at the bottom somewhere? What type of glue should I use? Any tips generally?

Thanks in advance!

Dave Jones

Post by **R0B** » 30 Apr 2007, 07:25

the glue to use is bostik.the tin with the brush in it.just pull the old one off.don't bother cutting it.you will be replacing it anyway....

Post by **joneseymagic** » 30 Apr 2007, 10:56

Thanks for the info re. the glue.

I meant that I will have to cut the NEW seal (which is one continuous loop at the moment) at some point, as I don't want to take the door off.

I suspect I should cut the new seal at the bottom - any advice?

Dave

Post by **R0B** » 30 Apr 2007, 16:29

sorry i misread you.i would cut it at the bottom as well.

I suspect I should cut the new seal at the bottom

Post by **madmyk** » 30 Apr 2007, 19:51

Hi Dave,
Not certain that it would work, but why not just pop the rear of the door off, and slide the seal over? I imagine this would work, but can't say from experience. Best of luck!

Myk.

Post by **shepster** » 01 May 2007, 07:26

All you need to do is undo the bottom hinge and slip it over then bolt the hinge back up.

Post by **joneseymagic** » 04 May 2007, 00:53

Thanks for all the advice - much appreciated!

Dave

Club 80-90 Forums

Door seal

Door seal

Door Seal

Door Seal