Fitting a Propex exhaust

Post by **cumbriankeith** » 14 Jan 2007, 12:08

I'm about to do this and could do with knowing how hot the exhaust outlet pipe gets and therefore what level of heat insulation is needed to prevent mishaps in the storage area it passes down thro. Do I need to put a larger diameter metal pipe over the inch(ish) one or not?

Post by **DiscoDave** » 14 Jan 2007, 12:28

it does not get as hot as the ebber ones but still quite warm! where are you fitting the propex? all of the exhaust should be on the outside of the van!

Post by **Spannerrack** » 14 Jan 2007, 12:31

make the hole slitly bigger & use a high temp sealant

George