its a sad question, but

Post by **kevtherev** » 23 Nov 2006, 22:25

I think we stock M8x 50 1.25 pitch but just hex set

I'll check the lockers tomorrow

Post by **HarryMann** » 23 Nov 2006, 22:31

Ah, think they have a plain length too.

Rating? 10.9 (or better)

Post by **kevtherev** » 23 Nov 2006, 22:33

oh dear no plain...but the ratings ok

Oh well it was just a thought.
we stock quite a good selection of the general stuff..M6 to M12..nuts and flat washers lockers springers

Post by **HarryMann** » 23 Nov 2006, 22:38

Ok, well pretty close then, but...
VW charge about £1.60 +VAT (or more) ea. !!!

Wonder if JK or GSF do them, washers don't seem to come in the GKN kits, but they're 12p each from VW

Post by **kevtherev** » 23 Nov 2006, 22:48

I don't think the grade is right but these seem cheap

http://www.namrick.co.uk/default.asp

Post by **HarryMann** » 24 Nov 2006, 01:30

Ah thanks,

Socket cap heads 12.9 Zinc Plated

12.9 about the strongest you can get commercially. They probably have std. plain shank length, usually a few multiples of the diameter, possibly 2.5 x

N.B. Zinc Plated Socket Screws are de-embrittled after plating but remain slightly weaker than unplated screws. For maximum strength specify unplated (black) screws. (but aren't listed

)

Post by **"WEAZLECHIN"** » 24 Nov 2006, 07:43

well i learned a bit more then (every little helps) thanks chaps. its ok kev, im going past west brom fasteners later today so i`ll just nip in, theyre usually good, oops are they the opposition??

Post by **kevtherev** » 24 Nov 2006, 15:31

that sandwell club?

Post by **KevH** » 24 Nov 2006, 16:02

got a box of 100 of these somewhere,, if you can't get any i can stick some in the post for you.

Post by **"WEAZLECHIN"** » 24 Nov 2006, 16:44

sorted it. vw want how much per bolt ?... went up w/brom fasteners and got 12 bolts, 12.9 grade with 12 locking washers for £2. hhmmm