Plastic Oil Filler Tube [WBX - 1.9 DG]

[Georgedog]

WEhey.... Need some bits to convert my intake system to a DG Pierburg Carb .... So ....
I just bought a 2nd Hand engine with most of the bits n' bobs still attached .. I DO NEED a new plastic oil filler tube [mines cracked at bottom, has jubilee clip + pishes oil out !] and Lo + Behold .. the latest lump has a good un !
Anyway.... cut to the chase ... How is it fitted onto the lower metal pipe ??
how do i get it off ?? and will it go straight on my Lump /?????

Im assuming its a kinda push fit + just pulls off, but i have just dropped the lump off on m8's workbench .. and had no time to play ! !

Will start pulling bits off - apart on friday ............. ave' it .........

[Georgedog]

doh ....... DOH ....... DOH .......

Meant to put this in Tech Help !! Not Chittychatty Section .. apologies .. and if Mod' team want to move .. Feel Free !

Mind... theres more chat than tech in content ....
\

[Mocki]

change it at the metal end, onto the injun!
they never go back on any good if you seperate them at the plastic bit......



i moved this!

[Georgedog]

Mocki ... Gasket ?????????

[toomanytoys]

Yes use a new gasket and a smear of sealant... or it will "pish" out.......

[Georgedog]

Ta ...........

[MacAoidh]

I was talking to mocki about this the other day, he recommended general purpose grease, on both sides of gasket, do it up max hand tight