ok got in the van this morning take kids to school and the oil light was very dim but was on so stopped engine checked oil looked fine was between 3/4's and max so put around 3/4's of oil in (which was left over from recent oil change 3 wks ago from a 5 ltr tub) and after around 5 mins the light went off
now my question is have i got a fault? and how much oil should be put in on an oil and filter change? cheers for any info ROB!!
oil light???
Moderators: User administrators, Moderators
-
ROBS T25
- Registered user
- Posts: 1335
- Joined: 17 Nov 2005, 20:35
- 80-90 Mem No: 2292
- Location: NORTH WALES MEMBER 2292
oil light???
There are 3 kinds of people in this world.......
those who can count and those who cant!!!!!!!
those who can count and those who cant!!!!!!!
-
toomanytoys
- Trader
- Posts: 2868
- Joined: 11 Oct 2005, 18:37
- 80-90 Mem No: 41
- Location: Boston area, South Lincolnshire
min to max is only about 1/2 a litre,
if the level was at 3/4 why put more oil in? you have overfilled it and need to remove that excess oil asap
Oil light is nothing to do with levels...
If it is low pressure, the engine will blow up...
Dim light, would indicate to me that the wire insulation is cracked etc.. and dampness is "earthing" is enough (I have had this happen myself) Check the wiring from the switch and spray a bit of wd40 on it..
Get the oil pressure checked, just to be sure and prob a good idea to change the oil pressure switch in case its faulty..
Oh.. dont use anything less than a 15w40 oil and 4-4.5L is enough to fill to 1/2- max (including filling of the filterbefore fitting it)
if the level was at 3/4 why put more oil in? you have overfilled it and need to remove that excess oil asap
Oil light is nothing to do with levels...
If it is low pressure, the engine will blow up...
Dim light, would indicate to me that the wire insulation is cracked etc.. and dampness is "earthing" is enough (I have had this happen myself) Check the wiring from the switch and spray a bit of wd40 on it..
Get the oil pressure checked, just to be sure and prob a good idea to change the oil pressure switch in case its faulty..
Oh.. dont use anything less than a 15w40 oil and 4-4.5L is enough to fill to 1/2- max (including filling of the filterbefore fitting it)
-
Mocki
- Membership Admin
- Posts: 17260
- Joined: 29 Sep 2005, 09:27
- 80-90 Mem No: 428
- Location: Mansfield Notts
- Contact:
yep, there is apsolutely no point in refilling to take the reading on the stick from 3/4 between the marks to full, just a waste of oil, time and energy, WBX's always run at 3/4, and if you fill it back up, it will be back at 3/4 the next time you look...and if its any good stay there till next oil change.....well mine does.
as Si says, cracked insulation, damp morning, then warm engine.......light dim, then after engine bay warms up goes off..... common....
as Si says, cracked insulation, damp morning, then warm engine.......light dim, then after engine bay warms up goes off..... common....
Steve
tel / txt O7947-137911
________________
1989 2.1LpgWBX HiTop Leisuredrive Camper
1988 2.1 Auto Caravelle TS TinTop Camper
tel / txt O7947-137911
________________
1989 2.1LpgWBX HiTop Leisuredrive Camper
1988 2.1 Auto Caravelle TS TinTop Camper
-
ROBS T25
- Registered user
- Posts: 1335
- Joined: 17 Nov 2005, 20:35
- 80-90 Mem No: 2292
- Location: NORTH WALES MEMBER 2292
ok you guys cheers for that will get the wd 40 out then i only use castrol gtx oil 15w-40w thats all has gone in it since i have had it i change oil and filter every 3k mls
has never used oil since ive had it usually check it once a week and always the same thanks for your help ROB!!
has never used oil since ive had it usually check it once a week and always the same thanks for your help ROB!!
There are 3 kinds of people in this world.......
those who can count and those who cant!!!!!!!
those who can count and those who cant!!!!!!!