Suspension

Post by **Blofeld** » 23 Oct 2006, 20:08

Recently had the van lowered wanted 40mm cos the bay lowered morre and it gets annot=ying somethines

but fitting the JK spings pack droppit about 60mm. got a second set and that did the same.

Fed up know 'cos front bottom's out on large bumps and smaller ones at speed.

Alos think it's settled since fitted

thinking about going back to stock height unless anyone can think of good reason why this should happen or some good tried and tested spings for 40mm drop

Post by **kevtherev** » 23 Oct 2006, 21:06

Simon Baxter at Brickyard can help...he's a lowering Guru if ever there was one.

he may be of help with what you've already got

http://www.brick-yard.co.uk/

.

Post by **timthetrader** » 23 Oct 2006, 21:32

Kev wow what an amazing photo!

Post by **kevtherev** » 23 Oct 2006, 21:47

My daughters just taught me some adobe tricks

Post by **Westy.Club.Joker** » 24 Oct 2006, 07:52

Used the 40mm Jamex kit, didn`t actually measure how much it`s dropped, `coz I changed the wheels at the same time. I don`t get any clearance issues though (note that campers tend to be heavier towards the front side with all the camping and water tank stuff so you may need to "adjust" the front spring to compensate and get it level, I did)

Post by **Blofeld** » 24 Oct 2006, 19:58

thanks guys - gonna try and get my money back from JK. third time lucky - might to back to stock until i get to know the van bit better!