Update On Mystery Power Loss

Post by **BaaaadSlider** » 19 Oct 2006, 15:38

Thanks for the replies.
Please is anyone available to pop over and take a look at the van for us in return for some beer?

Post by **Mocki** » 19 Oct 2006, 15:43

hi BB, i'm mobile again now, when are you there next week?

Post by **BaaaadSlider** » 19 Oct 2006, 15:45

Mocki wrote:hi BB, i'm mobile again now, when are you there next week?

Hi, we both work days all week so would only be avaiable after 6 of an evening or anytime at a weekend, sorry not the best of help

Post by **Mocki** » 19 Oct 2006, 15:49

erm, not really much help, i am not available this weekend, and evenings is tricky....... is it undercover in a well lighted area if i can make it after dark?

Post by **Tex Ritter** » 19 Oct 2006, 15:50

Check the filter mesh at the fuel pump inlet pipe banjo bolt.

As its had a new pump fitted it's unlikely to be this, but some people are unaware that this filter mesh is there.

Tex R

Post by **BaaaadSlider** » 20 Oct 2006, 08:19

Mocki wrote:erm, not really much help, i am not available this weekend, and evenings is tricky....... is it undercover in a well lighted area if i can make it after dark?

No it isnt under cover and not much light either.
I could take it to work one day at Heckington near sleaford but thats even further for ya or could at a push bring it over to you if it helps?

Post by **Mocki** » 20 Oct 2006, 08:34

how "urgent" is this?

i am pretty busy next week now, playing catch up, perhaps the following week would be better?

Post by **BaaaadSlider** » 20 Oct 2006, 08:37

Mocki wrote:how "urgent" is this?

i am pretty busy next week now, playing catch up, perhaps the following week would be better?

Well ideally we would like to go to Whitby the weekend of 28th October

Post by **Mocki** » 20 Oct 2006, 08:52

pm me your mobile number, or txt me it, i'll see what i can do.....

Post by **toolsntat** » 20 Oct 2006, 21:41

Hi there, I had a prob like this and it turned out to be the rod that pushes against fuel pump.
It had worn down by about 5mm which allowed it to give just enough fuel for short runs and around town but on a long straight run the fuel would run out in the carbs....
I can`t remember the true length but if it is worn there will be a burr (VERY SHARP) on the engine end of the rod.
Good Luck and hope you get it sorted soon....

Post by **bennwedge** » 20 Oct 2006, 23:00

if your going to drop your tank make sure you pull out the two breather pipes from the top of the tank first. they are quite tricky to get out because you only have enough room for your arm , through the front arches, so its done just by feeling. i snapped one of my breather pipes fittings by not doing this and it was very hard to get a replacment. also you will almost certainly need a new fuel filler neck as they are always cracked and the back metal plate for your fuel cap. i found a lot of rust on the top of mine when i took it off. dont know if it will solve your problem though. it does sound to me like your getting some sort of blockage.

Post by **BaaaadSlider** » 31 Oct 2006, 09:03

Just to give you an update, Mr Mocki (thanks very much Mocki) has been and had a look and found that the pipe behind where you put the petrol in had a big hole in, so this has been replaced and the tank drained.
Me dad and I managed to take the carbs out and gave em a gud clean and put back together, now since puttin back together its worse than ever.
IT still starts fine, but doesnt seem to have any go in it though, top speed in third gear is 40, when i put it into fourth gear it just doesnt make a differnce.
I have given up and takin it to a garage today to see if they can suggest anything else.

Post by **BaaaadSlider** » 01 Nov 2006, 13:31

Ok so garage still havent found anything wrong with it-still no power but no explanation.
Any more ideas???

Post by **Mocki** » 01 Nov 2006, 14:31

Are you sure you have all the vac pipes back on properly?

How much water did you get out of the tank?

Post by **BaaaadSlider** » 01 Nov 2006, 14:39

Mocki wrote:Are you sure you have all the vac pipes back on properly?

How much water did you get out of the tank?

Got quiet alot of it and think vac pipes back on properly

Club 80-90 Forums

Update On Mystery Power Loss

Re: Update On Mystery Power Loss