Club 80-90 Forums

looks to have had the LDA capped off?? How does it run (apart from the spindle leak)? You may be better off converting it back to a proper TDi if you don't know anything about the install??  they look like proper TDi injectors? It runs ok I inherited this setup it was put in 2005 and I got the camp...

The fuel comes out here

Pump 
I do have recorded it but can’t upload the video 

Engine is 1Z fuel pump mechanical of what I have no idea
Any advice very welcome

T25boy71 wrote: ↑05 Feb 2023, 18:20 Clutch and flywheel removed it’s 215mm 
Is the seal behind the flywheel universal 

Clutch and flywheel removed it’s 215mm 
Is the seal behind the flywheel universal 

https://i.imgur.com/rF1iIXu.jpg https://i.imgur.com/wb51zP6.jpg https://i.imgur.com/m15VETt.jpg https://i.imgur.com/JwEcwQ6.jpg https://i.imgur.com/9QT5CXN.jpg Ok so sorted out the pedal side  I’ve drop the gearbox the clutch release bearing has rotated a bit and jammed the fork there’s a lot of mu...

Found a new pin From JK have them more pricey than BW but I needed it so what can you do.
I will probably just weld and drill new hole but if Vw had made the pedals the same gauge metal this would not wear out like this

Just an update  https://i.imgur.com/SFcX7vD.jpg https://i.imgur.com/OFRZPxG.jpg https://i.imgur.com/wulfhLd.jpg the pin and hole in pedal have lots of ware and the clevis was jamming on the underside of the pedal. I did notice the clevis is much wider than the arm  https://i.imgur.com/HnsNuhK.jpg I’...

Assuming that the fuel lines (including all the clamps/fittings) are all in good order, it's possible the pump is worn and allowing fuel to drain back when the van is left idle for a few days.  I had the same symptoms and fitted a primer bulb in the fuel line between the filter and pump (as close t...

mioba wrote: ↑08 Dec 2022, 19:45 No need to drop the box for the leak. There is a blue spring loaded washer in there. Undo the selector. Pull it out and replace washer.
The nut has a very low torque - dont overdo. you will snap the end.

When was the fluid last changed - bled.

I’ve not done a fluid change on the clutch side.

check the bolts on the clutch slave, ive had the pushrod pop out and jam, have someone operate the clutch and watch what all the bits do to rule out something quick and simple  The slave pushes down about 10 to 15 mm on the arm below it  the pedal moves about 50/60 mm then stops  if I unbolt/loosen...

I did see that post I’m having trouble getting my hand up to the pin, there is a small amount of movement on the clutch pedal and when depressed the slave cylinder has some movement on the arm on the gearbox but not much, i did notice a very slight slip in the clutch like a delayed release then I wh...

Was driving went to change gear came out of gear wouldn’t go into another gear so so coasted into a layby. Tried to put it in gear wouldn’t go in clutch pedal doesn’t fully depress managed to start it in gear and drive home without using the clutch clutch release, bearing has always been noisy  any ...