Club 80-90 Forums

These are the pipes I’ve used to replace the missing steel ones long since rusted away


Sent from my iPhone using Tapatalk

Sent from my iPhone using Tapatalk

I was away at Brean sands last weekend and while booking up the electric, I put mine under the van as I didn’t want a flap or a whole in the side I noticed the heater pipe that runs from the rear cross member going forward under the tank was a sagging a lot ! Got under there and indeed it was heavy ...

I have a similar issue with both my doors after fitting new seals , I’m thinking it’s the routing of the seal over the hodge bolts making it difficult to shut have to really slam them , Can someone upload a pic of the route of the seal on the hinge side of the thier easy to close door [emoji51] Sent...

i wonder if you could do me a favour while your pulling out your dip stick , could you measure it for me from the bottom to the point at which it stops in the tube , mine has broken and been welded in a previous life and im not sure if it gives the correct reading , thanks very much 

I have one , I’ll post up some pics of the work I did to get mine working properly

Post up some pics of yours prop it up and let’s have a look at either end we’re the gas struts are or should be

Started on the canvas today , ordered a nematic staple gun to attach the top edge , made it so easy to attach it to the GRP , the bottom edge is pop riveted along a ali strip that’s the next job for the coming week as well as the poles that hold the canvas in position https://uploads.tapatalk-cdn.co...

Got the roof back on , gonna fit the new bars and gas struts at the weekend may even have a go at the canvas [emoji51]


Sent from my iPhone using Tapatalk

Sent from my iPhone using Tapatalk

I’d like to thank Tony for letting me come over take his roof apart for me to draw round a part which is so rare thanks Tony , Ive been busy and made a couple of the missing parts I need for my Danbury Auto Roof which is no longer auto ! I’ve been restoring this this thing ! For 8 years nearly and m...

Sent from my iPhone using Tapatalk

I did have a fresh water too it was located inside tho it too had an inspection hole with a screw on cap big enough to get a hand though , I would think they all do


Sent from my iPhone using Tapatalk

Is it a waste tank the one I have had a inspection hole I’ll post up a pic later


Sent from my iPhone using Tapatalk

That’s really great thank you , weres your bellows Got too I had a new one made for mine from proud to pop I sent them the old one and they used it as a template for the new one , I’ll post up a pic once I get it fitted now I can get on with the roof Thanks again for the info Sent from my iPhone usi...

Thanks that would be very helpful, I’m in the Midlands unfortunately, but the pics and info would be Great thanks