Club 80-90 Forums

Think i need to make up apair of drive shafts with boots and constant velocity joints for my b reg t25 petrol 1.9....Can any one tell me if they are a standard length .. Air cooled\2.1\1.9 petrol..i was going to make a set up and have the garage fit them for me ?

it is not cold start white smoke..not oily smelling ..not exhaust smelly ..one time after bleeding the new brakes you could not see behind the van..recently it is a noticeable difference from cold start.. fluid tank has emptied over a couple of days.. when you press the brake pedal you can here flui...

Well that was a waste of a post from me. Would the servo diaphragm have to be punctured though Martin? Diagram seams to work..and the inlet for the vacum on the servo is rather high..am going to replace master and servo..is it steering out clocks out to do the job. .thanks to all with the very help...

Condensation? How's the water level? Water level is fine. ...have had issues with brakes. .replaced calipers new rear every thing lost fluid a few times...master and servo bit wet may be from filling...can fluid get from master into the servo down the vac pipe into the manifold. ....? No smoke this...

Dad wrote:Condensation? How's the water level?

Need daylight will double check tomorrow ...

Oldiebut goodie wrote:

peggy wrote:there is a lot of white ish smoke when cold..reving it to clear it does not help... clears when warm...engine sounds fine...1.9dg motor...where to start investigation first..any clues please....oil level ok...no temp problems...mot soon ..

Maybe you have overfilled with dots.

What is dots..?

there is a lot of white ish smoke when cold..reving it to clear it does not help... clears when warm...engine sounds fine...1.9dg motor...where to start investigation first..any clues please....oil level ok...no temp problems...mot soon ..

pas from a corsa I was told was relatively easy installation ..fabrication of bracket cut steering column sleve it weld a d connect power. It's a professional task, if you must do it get it done properly and AFTER you inform your insurance company. or was the bloke from stoke at Oswestry full of it...

smaller pas padded wheel. some from mk1 golfs with adaptors. Either way it's going to be hard going when parallel parking. Cheaper to change the seats than fit pas? Nice one. ..does the centre boss on the mk 1 golf fit the transporter colum...pas from a corsa I was told was relatively easy installa...

Any idea what steering wheeis will fit....need to have a bit more leg space after fitting some new seats bit smaller would help.....to small and I may need power steering. .vaxhall I believe may be fitted any ideas out there..thanks. ....

What other car seat fit with out to much hassel..sabb i know but there must be others..can any one help...t25

1985 t25 front brake caliper needs sorting bleed nipple needs replacing..well rusted spanner is no good.looks like a mole grip job...can i put some heat on caliper before i try..may have to remove ..replace and bleed .next dust seal needs replacing and a good clean ...may stop that dame squeak when ...

thanks everybody now i know...all about peggy ... got back from the blackpool breeze...what a mud fest...not good ..made the best of a bad job..

nice one...if date of manufacture is there what does the plate by the door tell me.....off to blackpool breeze in the morning...

number reads wv2zzz25zeh090398 what does this tell me .....hope somebody can help me find peggys birthday or is there another plate -number some where else....