Club 80-90 Forums

Hi All,

Got some Avo adjustable shocks for my T25.  Which way do I turn the adjustment to make them stiffer, never had any documentation with them:(

Cheers
Dave

I bought some wheels for my van however I have had to remove the bearing caps on the front to get them to fit.  Now I know they are there for a reason so would have preferred they stay on however.  My main problme is know the speedo cable does not sit in the cap, therefore it does not work.  Has any...

HI All,

I have quite a bit of play in my passenger seat.  Its on a swivel base.

Is this what I'm likely after?
251881320A/319 Swivel Seat Bushing Set VW T25 1979-1992 J43944 J43944 | Just Kampers

Hi All,

I am running different wheels so have had to remove the front caps which has made the speedo cable inop. I have managed to lock into place with a piece of metal but would love to know if there is a more permanent solution that anyone knows about that can be purchased?

Cheers
Dave

Hi All,
I have an aaz engine and box for my van.

What other bits and bobs am I going to need to complete the conversion? I have done some searching and I presume I need a JX sump?

Cheers

Filter and lines are all ok. Once fired up after putting fuel in carb, it is fine. Just when left over night I presume the fuel falls back and needs pumping up again hence why I was going down the line of changing the fuel pump rod. I see what you mean about the float chamber being full, and I think...

Hi, Have an issue with my DG engine. Will only start when you put petrol directly into carb, then after engine is warm, starts on the key. Leave it a couple of days and engine just turns over and over and wont start until petrol is thrown in the carb. Do you think I ought to replace the fuel pump pu...

Many thanks
I will give it a try

Hi All,

Running Avo Adjustable shocks, not adjusted since install.

Finding it too bouncy on the front, how do I firm it up? (Which way to turn the knob:))
Cheers
Dave

10.5v without engine runnning, they look the same with it running tbh. I only measured the voltage at the fog light because that seems to be the one that is not very bright

Hi All, My rear lights look abit dim, I have measured the voltage to the rear fog light and can see about 10.5volts. After reading the sticky I have cleaned the earth on the left hand side of the engine bay and checked the light connections and cleaned them. Is there anywhere else to check? Is aroun...

Many Thanks for clearing that up...did not want to miss anything out

Hi All, I have started to renew my rear brakes and naturally bought new springs etc in a kit. My question is I am left with a horseshoe clip and a slightly curved washer. I have yet to connect up the hand brake cable. Are these bits I have left required for the handbrake cable? Van is a 86, 1.9DG Ch...

Are you still stuck with this?

Hi, Im trying to wire up a positive feed for a clock and require one that provides 12v when the ignition is on only. I have had my tester round the wires to the ignition and they seem to provide 12v constantly. Anyone know of a feed that is provided only when the ignition is on? Cheers for your help...