Club 80-90 Forums

Eta-Beta wrote:use a pencil grit blaster on low pressure, and wide fan at nozzle, worx a treat.

cheers new there must have been others with the same problem.

Thanks folkers will try to get hold of a extension are they available from all diy places
sorry to sound a bit thick but not heard of them before.

Has anyone got any ideas on how to sand down and paint behind this little beggers. Unfortunatley I can't dislocate my wrist to get in. Just wondered if there were any tested ways to do it. Any suggestions welcome. http://i976.photobucket.com/albums/ae250/blue_bird_01/vent1.jpg Hooray after half an h...

We went there in 2006 stayed on a small site just outside Kaprun which is not far from Zell an See. We were on bikes though, don't think the van would make it up and over. It's very beautiful well worth a visit and if you fancy there is an extra bit of road that takes you to the very top, think it i...

Forgive me for being a bit thick but what does iirc stand for.

Thanks Aidan Will keep these in mind for future reference. On the parts we had from JK I rang them and explained the trouble we were having their reply. Not had anyone else ring with same problem but they did say if we found parts from any where else that fitted better they would refund our money. S...

Ye in this case think you are right but unfortunately some parts we have needed Brickwerks have not had them, so ended up ordering from JK.

If you know of any other places to get parts from would appreciate this info.

Hi Aidan don't think I explained right correct me if Im wrong but the item you talking about is the metal washer plate. The problem we have is with the rubber bush and rubber damping ring as in pics. http://i976.photobucket.com/albums/ae250/blue_bird_01/T25/Dampingringforcrankedantirollbar.jpg Dampi...

Just checked the damping ring (as changing these as well) it would appear that they are different that the ones shown on JK web site, the ones on the site have a rounded edge the ones we received have a straight edge. Steve put old damping rings back on now it lines up. Has anyone else ordered these...

Todays job was change the bushes on anti roll bar as worn. Getting it off was ok putting new bushes back on not a problem but what are we doing wrong can't get the bar back on. Can get bar link in place with a struggle but does not seem to line up properly and as soon as we tighten everything up the...

Don't know how common be we have a small leak in the same area.

Will keep checking your post for replys.

We are looking to do the same, went a caravan breakers had a look at some there although we were short of getting a full set by 1 (needed 4) was assured by the guy if we kept popping in would drop on a set eventually as they were always having new vans in. Most of them were in good condition and the...

Great
thanks for that, good information on the quailty not really thought about that was
just thinking about it fitting not wanting to waste any cash. Will follow link.

Thanks again

Steve

Now we have some cash looking at replacing old one ites been patched up a few times. We have been looking at two in jks. One is a single quietpack it states that the rear valance may need ajusting. Just wondering if anyone has fitted one and if they had any problems, did you have to adjust anything ...

oldiguana wrote:if eets ok to weld it...i might be able sort thee ite owduck!!!!!!

thanks foer th offer owdin,ar ave to weyt to geet confo fost!! Did'nt know there were any members in sunny stoke.