Page 1 of 1

Breather pipe

Posted: 18 Aug 2011, 16:04
by DUSTY100
Hi,
I've been told to check the breather pipe on my T25 1600 non turbo Diesel engine because oil has started to come out of the dipstick where it joins the engine block,can anyone tell me what I am looking for and where to find it and when I've found it what to do with it e.g clean it out of replace it??

Regards

Pete :run

Re: Breather pipe

Posted: 18 Aug 2011, 16:40
by ewenmaclean
Hello,

I think you're looking to check the CCV valve (Crankcase ventilation) - if it fails then the crankcase pressure from blowby gases forces the pressure out of the dipstick sometimes. The valve sits on top of the cam cover and is often referred to as a "puck". They are usually sealed I'm afraid so replacement is best.

Ewen

Re: Breather pipe

Posted: 18 Aug 2011, 16:45
by DUSTY100
Cheers Ewen,
There is a pipe on top of the crank case is it worth taking that off to have a look as it is fitted with two jubilee clips??

Pete :run

Re: Breather pipe

Posted: 18 Aug 2011, 16:49
by ewenmaclean
hi,

if it's on top of the valve cover, connected to a "puck" and goes to the air inlet somewhere, then that's the one I reckon. Sorry not overly familiar with the exact layout of the CS engine..

Ewen

Re: Breather pipe

Posted: 18 Aug 2011, 17:01
by DUSTY100
I will have a go later on when I have plucked up enough courage!!

Cheers Pete