Club 80-90 Forums

Just landed while I was off at vanfest, will be on shop later this week.
2 pieces, upper and lower, Stainless steel.

Cant decide if they should be a complete kit with rubber bobbins and nuts and washers etc, or just the bare clamp?

Another top product from the Baxter .

Ps.
What are the advantages over cable ties, that I am using at the moment.

bobbins are always shot and cable tied together

I'll Second that Aidan as my fuel pump is also cable tied with a ring of rust stuck round it so a full kit ready to fit would be the requirement for me.............

And me.....

.. and keep checking pump body for bad corrosion and sort if so, maybe rare, but can leak badly

And will probably be worse with stainless against ally.
They will need insulating to stop electrolysis.
Most aftermarket pumps now are much slimmer, with a rubber sleeve to take up the "girth"

<< Clicky >>

Site down,. Are you selling the 'rubber bobbins ' seperately?
Are they as per original ones?

Just updating the webshop.
Bobbins are JX air box mounts, little bit shorter but loads more robust (with them being from a Diesel, of course)