Page 1 of 1
Big Bumper fixing
Posted: 27 Jul 2010, 12:05
by chrisevans
Can someone help with the fixings or photos of fixing for front and rear genuine plastic bumpers on a T25/T3. I have the bumpers but want to attach them properly.
Re: Big Bumper fixing
Posted: 27 Jul 2010, 14:25
by lhd
Front bumpers should have two metal stays attatched to bumper the other fixings are available from Brickwerks.
Not sure about rear bumper though.
Rob.
Re: Big Bumper fixing
Posted: 28 Jul 2010, 11:53
by chrisevans
I have the stays which I pulled off another van - I will re weld these. I also have the hex headed bolts which are listed on BW. What about the bolts at the side of the steps?Mine is a 91 panel van with small bumper so doesnt have the correct mounts I believe.
Re: Big Bumper fixing
Posted: 28 Jul 2010, 12:02
by PeteIOM
My front bumper had two allen bolts in the front and one either side pretty much directly beneath the floor plates. Should just wiggle up a bit and then out..
The rear.... well that's giving me a headache. Theres two screws at the back and underneath and one each side underneath.. but still it wont budge!