Page 1 of 1

Full Throttle

Posted: 22 Jul 2010, 14:35
by albertramsbottom
Emmmm

I dont think im getting full throttle on me van as it wont go much more than 60.

\when i push the pedal down as far as it can go, I have noticed that the carb mechanisium is only two-thirds the way open, and the balance bar can be pushed at least another inch or so. Is this right?

Should the carbs be right open when the throttle is right down? or should there be some movement left on the carb mechanism?

Cheers

Re: Full Throttle

Posted: 22 Jul 2010, 14:50
by riffboy
Can you accelerate up to the marks on your speedo??

If so i would imagine you are getting full throttle.

I have a 2 litre Aircooled and 65-70 seems to be about it really depending on gradient lol.

Are you fully laden too?? that my have something to do with it.
:ok

Re: Full Throttle

Posted: 22 Jul 2010, 15:20
by jason k
full throttle should open carbs wide open.

adjust or replace your (stretched cable) 85mph is achievable.

Re: Full Throttle

Posted: 22 Jul 2010, 15:39
by riffboy
85mph?? Sweet lord!!

I better get me linkage checked! :idea

Re: Full Throttle

Posted: 22 Jul 2010, 16:53
by albertramsbottom
Cheers guys

Just had it replaced so I will test it tomozz :D :D

Re: Full Throttle

Posted: 23 Jul 2010, 19:15
by AngeloEvs
There is a a linkage under the pedal that is adjustable. I find it easier to remove the indicator assy to access and adjust the linkage. Details and tolerances are in the Haynes manual IIRC.

Re: Full Throttle

Posted: 23 Jul 2010, 21:46
by Plasticman
albertramsbottom wrote:Cheers guys

Just had it replaced so I will test it tomozz :D :D
I wouldnt be able to wait :rofl
mike

Re: Full Throttle

Posted: 26 Jul 2010, 11:56
by albertramsbottom
AngeloEvs wrote:There is a a linkage under the pedal that is adjustable. I find it easier to remove the indicator assy to access and adjust the linkage. Details and tolerances are in the Haynes manual IIRC.

Cheers, it goes better but im still not getting quite full throttle

Cheers