Club 80-90 Forums

Hi All,

Apologies if this is a stupid question, however I wanted to know that when repairing a patch of rust from a Seam, once sand blasted to remove old seam filler and rust proofed using Vactan, what seam filler should be used and where do i buy it from ??


Many Thanks
Nathan

'Silkaflex' seems (hee-hee, geddit?) to be the normal choice. I'd have thought most motor factors would stock it...

I'd heard that Tiger Seal is good for the job too.

CLICK TO SEE

Cheaper on eBay though.

I think silkaflex and tiger seal are very similar, silkaflex seems abit cheaper.

Put some masking tape down the sides of the seams then run thr gun down the seams, i think i just used my finger to smooth it.

Sikaflex is quite expensive, my local motor factor sells a different brand (same stuff in tube, air curing urethane) for half the price, can't remember brand but shop around

Thanks everyone for your help, ive now purchase some Silkaflex. Many Thanks