Page 1 of 1
Washer hose connection
Posted: 24 Jan 2010, 14:56
by sjmtlewy
Just pulled off one of my washer jets as it was loose. I tested the jet while it was out of the hole and it appeared to be leaking from the back of the jet. Behind, it is connected to a plastic tube, via a 1/2" piece of rubber hose. This struck me as a little odd, is this the same arrangement others have, or should the jets push directly into the plastic tubing? Not sure its wide enough though...
Re: Washer hose connection
Posted: 24 Jan 2010, 15:26
by 1664
The plastic tube goes straight over the jet inlet and the rubber goes on top of that..........at least that is the way mine are, and they don't leak. If you've knackered the retaining clips on the jet getting it out you'll have to get new ones as they'll let rain water in.
Re: Washer hose connection
Posted: 24 Jan 2010, 15:30
by sjmtlewy
Okay, that makes sense.. cheers.
I'm replacing the jets anyway as they were very loose.