Page 1 of 1

carburettor pierburg

Posted: 25 Feb 2009, 18:25
by mrging
hi i just got a t25 auto sleeper 1.9 water cooled and it has a flat spot when pulling away u have to dip clutch and give it a bit more gas or it will stool.
it has the pierburg carb not sure if 2e3/2e4 but it has high mileage and manual says replace it but it is fine when moving.
it is the same if hot or cold?
many thanks :?

Re: carburettor pierburg

Posted: 25 Feb 2009, 18:42
by VWCamperfan
New accellerator pump diaphragm needed. Allows a little more fuel through the carb when first pushing on accellerator due to the air moving first before the fuel gets a chance to catch up. Yours will probably have a small hole in it and not supplying enough fuel in time.
The accelletator pump is adjustable though (there is a nut on a threaded bar) and can be set to allow a little more fuel through at that time. Might be worth a check first just to make sure someone hasn't 'tinkered' with it! :D

Re: carburettor pierburg

Posted: 25 Feb 2009, 21:27
by Fritz
Check the choke 'pull down unit' is working properly , the one on our carburettor was not working and gave us similar symptoms


Regards


Fritz,,,,,,,,

PS, if you need one Dr Baxter has these in stock,,, :D

Re: carburettor pierburg

Posted: 25 Feb 2009, 21:31
by mrging
thanks fritz and camperfan will try this tomorrow