Club 80-90 Forums

Does anyone know where i can get hold of a rubber water hose reducer with 32mm at one end and 38mm at the other so i can join old metal 32mm long water pipe to new 38mm plastic replacement pipes ????

Theres a prob. If it were me, and I'm not absolutely sure it would work, is find a hose somehere in between and force one end on, and tighten the other end down with a jubilee clip? Sounds a bit barbaric but otherwise try a hose specialist and see what they can come up with.

these people might be able to help.

http://www.venairsport.co.uk/index.php?cPath=42

Thanks guys - managed to get some silicon reducers direct from a manufacturer for £3.75 +vat each - saved a packet by searching around - now for the hose clips....

Glenn - please post that manufacturer's name!!! As I could do with some too....mine currently is the atrocity aforementioned by Cov kid.....the right hoses for the plastic pipe, with an arrangment of Tube and clip to reduce it to the old system

The properjobbies would be brill!

Em
x

I got mine from www.demon-tweeks.co.uk

got mine from here

http://www.hoseworld.com/acatalog/SILIC ... UCERS.html

under the silicon reducers section.
Total cost for 4 with vat and p+p was £25

sorted - if youre going to do a job do it properly and you wont have to do it again - hope this helps

It surely will - thanks! Perhaps you could stick some piccies up of the finished thing? taa

Em
x

(ps -
mods - does this need a wiki link???)

i will try - i just have to spend a few more days under the van when the bits arrive - oh what fun

glenn77 wrote:i will try - i just have to spend a few more days under the van when the bits arrive - oh what fun

ummm know that feeling well!

Good luck
Em
x