Page 1 of 1
Just failed MOT on sills
Posted: 18 Jan 2006, 10:31
by mushroom
Do I have to replace the whole sills ( inner and outer) of can I patch the old ones ?
On MOT sheet it just says rear part corroded
If so where can I get patches or do I have to make my own ?
Posted: 18 Jan 2006, 11:42
by purplechugster
Which bit is corroded?
I had an MOT failure on the sills as it was near where the seat belt bracket is
...But I got it welded for negligible money and it passed fine
Posted: 18 Jan 2006, 14:05
by mushroom
it's the bit near the rear suspension mountings
Sills
Posted: 18 Jan 2006, 14:32
by cumbriankeith
I patched a couple of small holes on mine (right next to the rear jacking points - as long as the welds are continuous and it ends up solid and neatish it should be fine - mine was!