Club 80-90 Forums

i've got a dg 1,9 cc water cooled petrol engine#
g reg
1990
thinking about adjusting carb - am assuming - staring up at me is the idle speed screw - long - flat blade screwdriver adjustment - 900 rpm give or take 50 rpm says haynes - currently - just under 1100 -

my q is - where is the co2/emission screw? b good to know - if looking down on carb - with idle screw facing u? 2e3 caRB -

i thank yew in advance -

( has anyone done a map of an dg engine? like hip bone connected to.... water pump connected tp... b ruddy useful....)

i got it!

2 inches below idle screw - in its own little housing cover - can see a place for a flat bladed screwdriver -

may need to get the alfords equipment to set up - measure - adjust -