Club 80-90 Forums

Hi

I got a set of Audi alloys for my type 25. To get them to fit safely. I know I'll have to lengthen the studs for the rear.

Though how do I get them to go over the bearing housing at the front. I suppose I'll have to ream the centres of alloys out.Any advice on how to do this?

thanks

Nesty

where are you.fill your profile in.someone in your area may know an engineers who might do them for you.you may need spacers as well.and longer studs/bolts on the fronts...

nesty wrote:Hi

I got a set of Audi alloys for my type 25. To get them to fit safely. I know I'll have to lengthen the studs for the rear.

Though how do I get them to go over the bearing housing at the front. I suppose I'll have to ream the centres of alloys out.Any advice on how to do this?

Hi

I put audi's one Bill this year. I had to replace the rear studs with longer ones, took off the brake drum and hub, pressed the old ones out and then had to use a 10 ton press to get the new ones in. Front i took to a little industrial unit where there was a metal fabricator and he bored them out for about 8 quid each.

If you're norfolk way will let you know where

Hi

Many thanks for the replies. I might be going to Sherringham on Friday for a break.

Nesty