Page 1 of 1
rev counter question
Posted: 09 Jul 2007, 23:27
by sandcrawler
im going to fit an after market rev counter,will i have to run a wire from the coil to rev counter or is there already a wire that runs up to the instrument pod that i can pick up from ?
regards
Alister
Posted: 10 Jul 2007, 07:29
by tonytech
I think it depends on when your van was made and what its original use was. (panel van, Caravelle, etc)
Wire should be red/ white stripe I think)
T
Posted: 10 Jul 2007, 22:12
by mininut
Fitted one myself a few moths ago (piccie of it in 'garage'^).
Two wires to your coil (+ and -)
One to an earth (body)
One to your side/head light switch.
Simple as that
Posted: 11 Jul 2007, 19:15
by guz
mininuts wrote:Fitted one myself a few moths ago (piccie of it in 'garage'^).
Two wires to your coil (+ and -)
One to an earth (body)
One to your side/head light switch.
Simple as that
i've only got one wire to my coil
and it works fine.
wire it to the right part of the
switch and illumination dimmer
should work too.