Page 1 of 1
alloy fitting kit.. wotch think
Posted: 22 Apr 2007, 20:34
by wookey
Appolgies if this is already been done ..
Just seen this
http://cgi.ebay.co.uk/Vw-T25-transporte ... dZViewItem
wondered what you guys think of this method? strength on the adaptor would be my primary concern.,
I like the idea, fitting a set of alloys without the hub showing and the possible combinations are cool..
thanks wookey
Posted: 23 Apr 2007, 08:41
by poshbuggers
My concern is the thickness of that adapter where the hex bar slots are.
Even the cheaper made steel adapters have full thickness around the bolts and as these aren't hubcentric (no central location point) I question the safety of using a non-centred, thin aluminium casting to support the weight and forces of a van wheel.
A genuine wheel spacer for a Porsche 911 which uses the extended stud principle can be up to 80mm thick. The difference being the spacers are hubcentric and the bolt holes are aligned to the original bolt pattern.
TBH I would rather buy a set of H&R spacers (available from Charlie at
http://www.t3tuning.co.uk) which yes, are more expensive but are inherently stronger, better engineered and proven.
Posted: 23 Apr 2007, 08:45
by g60steve
Ouch!!
IMHO....Leave well alone.
Posted: 23 Apr 2007, 09:36
by wookey
some pretty big concerns there. I've just been looking at the extension bolts again. THe walls are just too thin to withstand the loads involvled..
This job is worth doing right, and Im sure now they are not the right tool for it. Cheers
Posted: 23 Apr 2007, 12:47
by Other-Power
Ebay ones small print
"The user of any of our products assumes responsibility for all risks when fitting, modiyfying or adapting any part of our product or their vehicle"
T3 Tuning
"TUV approved"
Simple ahy
Jon
Posted: 28 Apr 2007, 09:39
by kyleewyleecoyote
Whole speill(?) sounds like something off the shopping channel. Over complicated design for a situation that already has a solution (spacers & longer studs/bolts). How do you get the correct torque and/or just line the hex ends up (fidly).
Posted: 29 Apr 2007, 20:27
by Simon Baxter
One of my suppliers sells them.
I don't.

Posted: 10 May 2007, 22:33
by darkelk1966
i had one of those kits fitted to a mini i owned
front offside wheel sheared off trying to give it some poke up the main road,
wheel traveled 500yards further than the car did lucky it didnt hit any thing
grayston make them utter sh*te