Page 1 of 1
Skimming Exhaust Manifold
Posted: 06 Apr 2007, 14:36
by wookey
I've found the exhaust manifold is corroded on no 4 port. causing a leak even with a fresh gasket.
So how much can I get skimmed off the face of the manifold. Looks like I need to cut about 2mm off it so that it seals correctly on the block again.. failing this.. anyone got a N/A diesel exhaust manifold.?? (wanted add posted just in case! )
Posted: 06 Apr 2007, 16:45
by Rozzo
use some firegum or exhaust paste,, that'll seal it
Posted: 06 Apr 2007, 17:48
by andysimpson
yes they can be re faced, any engineering place should do it for you in a couple of minutes.
Posted: 06 Apr 2007, 18:31
by wookey
so now its off do i paste it up? i suspect this would only be tempory due to pressures at the exhuast port? or wait till next week and get it refaced.. would i gain the much more? cheers
Posted: 06 Apr 2007, 19:18
by andysimpson
Get it refaced if you want it too last.
Posted: 06 Apr 2007, 19:48
by philippacman
aaron i may have one here will have a lock tomoz
Posted: 07 Apr 2007, 07:16
by futbus
take it to an engineering company, but most of the cost will be setting up, and as andy says its not a big job, probably only take 10 mins but setup would take twice that long. Any problems give us a shout.
Posted: 07 Apr 2007, 10:33
by Rozzo
if indeed it only needs 2mm off i would paste it (thats what the paste is designed for) and the pressure in there is not high as in like a head gasket cos its kinda blowing to an open end