Club 80-90 Forums

hello all
I bought some nice shiny hub caps at Dubroast. When I tried to fit them I found that the nsf one wont go on because the end of the speedo cable is in the way at the centre of the hub cap. Any ideas how to get round this please.
Richie

Richie, If your grider is still operational ,I'd be simply skimming the prowd bit off the end of the cable,,,,,,,OR even placing a socket (8mm) over the bit sticking out of the grease cap and giving it a whack with an FBH.

Regards

Fritz,,,,,,,

Thanks Fritz I will give that a go. The FBH seems to be a very common solution with our vans
Cheers

Everyone should carry an FBH to be on the safe side, it has a multitude of uses,,,,,


Regards,

Fritz,,,,,,

We call it a Gornal screwdriver in these parts