Club 80-90 Forums

Hi guys, must take out my interior to deal with rust and currently i am stuck removing the fridge unit. I have all the wires and piping disconnected and i think all the screws. However when i go to slide it out it feels like it is stuck in the bottom left corner. I have searched the forum but cant see anything and the manuals dont seem to golive advice on how to remove the unit. Its am electrolux rm212 unit. Any help is appreciated as always.

Gas pipe & outside vent ?

Outside vent is loose. Trying to upload pictures but have slow internet. Are the only gas pipes on the top of the fridge? They are all disconnected.

What conversion is it - might help elicit responses ?

Is an Autohome Kameo 3 conversion. Sorry should have said.

Try this with a link to the Wiki

https://club8090.co.uk/forum/viewtopic.php?p=8156284

Your photos at pb won't show unless you're paying them $400 / year now

Some shower ha. Thanks for the help though really appreciate it. Just found a screw hidden away by the heater and took it out and aeay the fridge slid out. Sneaky feckers. Thanks again.

Great, glad you got it sorted. Sometimes a break is all that's needed

Exactly. Thought i was cracking up there for a bit ha.
For anyone who stumbles across this thread that is in the same situation: autohomes Kameo 3 setup.

For fridge removal: electrolux Rm212 unit.
1.Disconnect the pipes and electrics on top of the fridge.

2.Unscrew the three L brackets on the top of the fridge that is holding the fridge to the units.

3.Also a screw in with the heater unit holding the lower left of the fridge in place. Might have to remove the heater like i did to get a screwdriver in to it

4. Check the flu on the outside also.

5. Should slide out then