Club 80-90 Forums

After buzz ticking over very low and lumpy since I bought him,I just read my Haynes manual and compared the carb.
on the top of my carb that I just lovingly cleaned it says pierberg 2e, in the Haynes manual I found an idle adjustment screw but it said 2e3 only .
i just adjusted the screw as per manual and now my tick over is purrrrrfect !

My point is which carb do I have or is there not a lot of difference ?

Df would not have come with a pierburg 2e3 so anything could have been fitted
This is the ref number of a t25 2e3 suffix may change
as you can see it has 2e cast in

On the front right top of the carb is stamped pierberg 2e with nothing else .I will take a pic tomorrow .

mickeyflyn wrote:On the front right top of the carb is stamped pierberg 2e with nothing else .I will take a pic tomorrow .

What is important is that number, 025129015 is a t25 2e3 carb.
it may well have 2e written on it as i have shown.