Club 80-90 Forums

Just found my accelerator cable has been joined near the carb with an electrical jointing block .i have new cable but it looks a nightmare to fit so any tips would be helpful .I can't even get my hand in to the space to undo the little nut at the front !

HAVE YOU LOOKED AT THIS ON THE WIKI YET?

https://club8090.co.uk/wiki/Fu ... eplacement" onclick="window.open(this.href);return false;

Ok thanks for that but THERE IS NO NEED TO SHOUT !!

What?

I done mine earlier this year and it's not that difficult really, mine took about 3hrs bc I drink tea and getn the wire thru the sleeves at the petrol tank was 'fiddly' lol
My old cable had unwound itself and was jamming in it's sheath, good luck.

Not sure if it is in the wiki, but I found taking the O/S/F indicator out let me get one hand through the hole and one hand under the van to get at it. There was just enough room to see what I was doing through the indicator 'hole' as well. HTH, Bri

Where did you get the cable from?

bought mine from brickwerks,not fitted it yet

Bought mine from brickwerks.

Thanks

garrytheskate wrote:Where did you get the cable from?

There are quite a few variations on left hand right hand diesel petrol etc, get it from brickwerks otherwise you will probably be going back and forth to the likes of GSF trying to get the right one.