Page 1 of 1
Threads and heads sizes
Posted: 02 Jun 2014, 17:19
by Smosh
This may come in use to some?
... Sorry, wasnt sure which thread to put this in.
Re: Threads and heads sizes
Posted: 02 Jun 2014, 17:32
by itchyfeet
Smosh wrote:
which thread to put this in.
Boom tish
Re: Threads and heads sizes
Posted: 02 Jun 2014, 18:28
by thebobster
Re: Threads and heads sizes
Posted: 02 Jun 2014, 20:39
by Smosh
i wondered who would get that!
Re: Threads and heads sizes
Posted: 02 Jun 2014, 20:49
by itchyfeet
Its a bit american, some threads are non standard like m7, m18
you can get the head sizes by googling 'bolt head sizes'
also worth noting head sizes have a tolerance
Re: Threads and heads sizes
Posted: 03 Jun 2014, 11:51
by silverbullet
It's generic but basically correct, probably based on BS/DIN standards? JIS (lke you'll find on a Subaru) are typically smaller a/f i.e. M8 = 12mm, M10 = 14 etc.
M7x1 is non-preferred but used on all modular alloy wheels
