pig
Well a long day.. got the gas tank back, seemed it had a snapped easy out in the hole

took an hour and a half and wrecked a cutting tool,but now helicoiled and happy

needs no words

the cooler works and fits fine but.... need to seal it from the engine bay , not looking airtight just generally separating it ,also have to be able to remove theis and also the cooler so a lot of thought needed and it turned out not to be so simple

first part trialed in
that was easy , the next has awkward contours to foillow and need to fit without removing any turbo hoses etc so ......playtime again

it works, took a few hours though

bonded rubber U channel round the edges ,this will stoip rattles and chaffing as welkl as helping seal a bit.
all in and happy

its tight in here but it all fits fine, i was going to fit the fan stat in here but the mounting bracket would have fouled the fan when trying to remove it so have opted to fit in the rear of the bay

its about 25c and i swithced the ign on and wound the stat up nfrom zero and as i got to 25-30 it kicked in, i have it ign fed through a relay so very happy with it.
fitted to new pad to the flap

of to take it for mot in the morning and have monkey sat inside to supervise
mm