Well,we go back a good few days, had issued with the booth burner electronics,sometimes life conspires against you no matter what, any how after all the pre gloss prep we do a final stopping up, looks like measles
but a pin hole in the primer = a glossy hole when painted
then final recoat.oh and there was also a major issue with silicone contamination which i wont go into now,so we are seam sealed, this way you have the seam coated etc with all the paints etc that you should and the sealer is there for show and to clean/neaten and finnish the join basicaly and it has a certain flexibility which we want
ditto
this horrible area is good enough now
and
so next step was the loose panals into the booth to be painted a proper colour
doors were quite straight and zero rot that i could find
same with tailgate, a nice one
then
nice new steel
all is now well in here and weve taken the paint round all the areas that will show including the screen pillars
this was the awkward little repair to the seal reccess
better view of this side
spent hours removing silicone sealnt (clear) from all the seals, .it was used as an adhesive
dumbo plus so much overspray , ran most of the bolts/screws etc through a wire wheel to get the crud off them and most things are looking nice now, new seals have fitted very nice to the glass, of the glass. hah wait and see but very nice
ive deleted a couple of picks as that useless p bucket accepts my editing as in rotating the picky i save and replace original and it still shows wrong way , i give up tonight
mm
) 
