Did you remove the Diesel feed and return pipes? are the pipes clear plastic?
When you did the pump timing did you have the cold start lever in the off position ( pushed home)
Check that the fuel filter is full.
Go through the pump timing again ( check that the pip on the pump sprocket is pointing to the pip on the backing plate at 11o clock)
Rig up a separate supply of Diesel to feed the pump.
1.6td won't start after cam belt change
Moderators: User administrators, Moderators
-
dave friday
- Registered user
- Posts: 804
- Joined: 15 Oct 2006, 11:19
- 80-90 Mem No: 5533
- Location: rambler de oria, near albox,almeria,spain
Re: 1.6td won't start after cam belt change
I dont think, so I'm not[do I exist?]
1992 1600td [ jx ] syncro panel van[leisuredrive camper ]
1992 1600td [ jx ] syncro panel van[leisuredrive camper ]
-
Oldiebut goodie
- Registered user
- Posts: 7482
- Joined: 18 Apr 2008, 01:19
- 80-90 Mem No: 11135
- Location: Eastern Angle
Re: 1.6td won't start after cam belt change
Looking back - it ran badly until the cam was altered after the belt change, something basic has been c**cked up there onwards. My money is that it was OK but one tooth out at that point and everything else that has been done since has made it worse.
1.6D 2019 VW T-Cross
200hp VW T6
1̶Y̶ ̶1̶9̶8̶7̶ ̶H̶i̶-̶t̶o̶p̶ ̶C̶a̶r̶a̶v̶e̶l̶l̶e̶
5̶0̶8̶d̶ ̶M̶e̶r̶c̶
200hp VW T6
1̶Y̶ ̶1̶9̶8̶7̶ ̶H̶i̶-̶t̶o̶p̶ ̶C̶a̶r̶a̶v̶e̶l̶l̶e̶
5̶0̶8̶d̶ ̶M̶e̶r̶c̶
-
tensilekid
- Registered user
- Posts: 46
- Joined: 14 Mar 2008, 11:27
- 80-90 Mem No: 4707
- Location: hereford
Re: 1.6td won't start after cam belt change
Hi I changed the timing belt on my JX and it would just about start but that was it found that there are 2 positions that the pump locking pin will fit! and guess what it was the other one !! I have now marked the correct one for next time as the pump was 180 degrees out with cam and flywheel .
colin t camper