Club 80-90 Forums

Opening a door? You can open T25s with a coin. Put one in the key slot and turn it

When you Hotwire it, use jumpers with male spade connectors on so you don't have to touch oe wiring

conkers wrote:Thanks all - as ever really helpful!

As it happened, after an hour of using a coat hanger to try to get in and get the door lock code I asked a T25 owning mate to pop over with his keys and they opened the drivers side door! (most worn barrel I assume) and I was able to get the door code from the barrel - just remember to prefix the code with an N before ordering!

Thanks

Hi,

Now you have the key code you will be able to work into any good locksmiths (not a shoe repairers/timpsons etc..) with this code.
As long as the it is a good locksmith they will have the necessary software to use you code to cut the correct key.
This will contain all the necessary cuts for the ignition and doors.
There are no transponders to programme so is a straight forward and reasonably cheap way of getting out of your situation.

Good luck