I'm happy with my decision to drill the hole. Easily filled if i ever wanted to take it off (can't see that ever happening) but its not such an eye sore even looking from the top.
It's a dedicated entry gland and never leaked since I fitted it
Best decision I ever made getting that bank on the roof. Second time away last weekend and it's pulling in some serious juice. September we are away for two weeks....no hook up. In fact we are wild camping on a few occasions.
Anyways, I finally go round to fitting the lower fridge draw.
Initially I was thinking of a drawer on rails. In fact i brought two pairs of rails, one for the chopping board which are utilized and effective at present, and the second set for the drawer. However, the slide out action of those particular rails is such that they only extend about 30cm out. For a drawer that has a depth that goes back far further than that it didn’t seem like an effective use of space if you can only access the front portion of the draw. There are other rail systems that extend out double the length of the rail, but these tend to be quite deep in design and would take up quite a lot of the already limited space, making the draw a lot narrower.
So the solution was a far simpler one than having to mess around with rails. We found a very low profile storage box that had an insert for the top portion allowing small items to be segregated. Things like fuses, light bulbs, remotes for devices etc. The bottom part was shallow, granted, but this would be for our tablets, blue tooth speakers etc. We brought the box from Rymans, and if I am honest it was a bit of a stab in the dark in terms of the size . I’ve got a pretty good eye for judging space and to me it looked too deep, which actually turned out to be the case. However, when the lid was taken off it fitted perfectly. So we lost the lid, which probably would have become a bit of a hindrance anyway.
So the basic elements can be seen here.
It doesn’t get much more complicated than this and it took me best part of an hour to construct. The drawer handle had been brought at the same time as the handle for the slide out chopping board. The white thing in the photo above is the aluminum sheet with its protective film on (which was a slice of a larger sheet that a friend got me for another project). All that was required to complete the construction was a small spacer to bridge the gap between the internal tray plastics, and the extruded strengthening elements surrounding it. This came in the form of a piece of hardwood that I found in my wood-store. Two holes were drilled in the Aluminum, wood and plastic tray to marry up with the holes on the handle. The screws for the handle needed cutting down a fraction, but all in all it was a really simple process.
This was all knocked together without having access to my van as it was in storage so I wasn’t 100% sure it was going to fit. I had used the original Westy fridge as a reference as this was in my garage, and a few photos of my fridge install from my phone. However, I was relieved to find that the drawer fit perfectly
At present the drawer is no more than a push under tray with a suitably matching front fascia on. I will most likely stay in place during travel, but I have acquired some very small, high power magnets. I plan to stick a couple of these on the back top edge of the aluminum drawer fascia, and a small countersunk head, ferrous metal screw at the corresponding edge of the framework on the lower fridge support. This should allow the drawer to locate shut with a nice crisp click
. After a service last year, and some emergency work to make the van safe by the good chaps at Brickwerks due to some seriously neglect in the radius arm and wishbone bush area by the previous owners... I was also informed that my engine was also getting tired and could do with replacing 
. I managed to get my hands on some new injectors, and a second hand sump has been purchased and cleaned ready for swapping over. Oh, and a new AAZ rocker cover to complete the install (Thanks Alex).
