Hello,
I am now undertaking refitting 'new' (2nd hand) Sliding door seals, and does anyone know, or can provide photos, of the correct orientation? There is quite a lot of contrasting information regarding the 5-inch flap section on one of the upright sections of the seal - I have seen it placed at the front latch, and the rear latch..
Any help appreciated
Cab and Sliding Door Closures
Moderators: User administrators, Moderators
Forum rules
Technical questions & answers only. Please try to search the Wiki or Tech Archive first.
Technical questions & answers only. Please try to search the Wiki or Tech Archive first.
-
- Registered user
- Posts: 17
- Joined: 08 Mar 2023, 10:01
- 80-90 Mem No: 0
-
- Trader
- Posts: 2599
- Joined: 27 May 2009, 18:56
- 80-90 Mem No: 16628
- Location: hayling island
Re: Cab and Sliding Door Closures
Lewis and Bee wrote: ↑21 Jun 2023, 10:13 Hello,
I am now undertaking refitting 'new' (2nd hand) Sliding door seals, and does anyone know, or can provide photos, of the correct orientation? There is quite a lot of contrasting information regarding the 5-inch flap section on one of the upright sections of the seal - I have seen it placed at the front latch, and the rear latch..
Any help appreciated
At the back, you’ll see when you close the door it fits around the back of the door , make sure
You have a RHD one
-
- Registered user
- Posts: 17
- Joined: 08 Mar 2023, 10:01
- 80-90 Mem No: 0
Re: Cab and Sliding Door Closures
Ok, super so is it like this?...
I feel it should sit a little lower, but the length of the rubber dictates to height, so i guess its right?...
There are still sources online which suggest it goes a the front. Most confusing
I feel it should sit a little lower, but the length of the rubber dictates to height, so i guess its right?...
There are still sources online which suggest it goes a the front. Most confusing