I'm sure this is all common sense but I'll ask if there are any tricks or potential snags on this job.
I have knocked up a wrench to hold the prop flange and I have all the seals, clips, bungs etc. plus a bit of plastic tube to tap the new seals back in.
I presume it's just a case of prise the bung out, remove clip with suitable circlip pliers and withdraw the flange, before prising out the old halfshaft seal?
Front diff seal change
Moderators: User administrators, Moderators
- silverbullet
- Trader
- Posts: 13986
- Joined: 08 Jun 2009, 09:51
- 80-90 Mem No: 6908
- Location: Surrey Syncronaut #156
- Contact:
Front diff seal change
85 syncro Caravelle twin slider Oettinger T3200E-6
90 SA Microbus supercharged wbx/UN1 project
http://www.025motorsport.com
90 SA Microbus supercharged wbx/UN1 project
http://www.025motorsport.com
-
- Posts: 1924
- Joined: 21 Feb 2012, 21:47
- 80-90 Mem No: 0
- Location: lancaster uk
Re: Front diff seal change
Yep...simple stuff.
- silverbullet
- Trader
- Posts: 13986
- Joined: 08 Jun 2009, 09:51
- 80-90 Mem No: 6908
- Location: Surrey Syncronaut #156
- Contact:
Re: Front diff seal change
Oof. I have just finished grovelling about and shoved it back in. All bolts are loose so I could go back to it, but since the cv flanges are dry I decided to leave them alone for now. Just replaced the prop flange seal and good job too, the dust seal was shredded and it had no grip left.
85 syncro Caravelle twin slider Oettinger T3200E-6
90 SA Microbus supercharged wbx/UN1 project
http://www.025motorsport.com
90 SA Microbus supercharged wbx/UN1 project
http://www.025motorsport.com