). I would like to add a factory power steering set up if at all possible and have had my feelers out for info / parts etc. The 16" panel has factory power steering to compare to. Aidan, as ever, shed some useful light on matters.We know that the 16" upright bearing housing differs from non ps in the casting but not sure if this is limited to just having two holes drilled for the steering link rather than one. Has anyone modded a non ps upright to go ps with? The 16" uprights are ££ as usual so would not like to make a bad call here. And there maybe half a chance of getting hold of a pair of 16" ps uprights but if it's 'just' a question of drilling a new hole well then that would be a good start.
Also I have a RHD rack but not sure this will be straight forward as the Syncro may have a slightly modified rack ( internal?) and again do we know what the differences are. Are there any further differences for 16" ( did any of the very few RHD 16" ever come with ps if the rack was that 'special')
I have asked about anyone converting to 16" factory ps over on IG16 but as I can only post in English , understandably I've not has a response as yet.
In the meantime I await news of an alternative ps route from our R&D dept.
