My question is regarding the pressure plate. Is there more than one way to position it on the dowels? My gearbox/input shaft aligns and fits fine. I just wanted to make sure i haven't messed the pressure plate position up?
Cheers.
Clutch Pressure Plate
Moderators: User administrators, Moderators
-
The Hairy Camper
- Registered user
- Posts: 399
- Joined: 03 May 2017, 00:19
- 80-90 Mem No: 16820
- Location: Cheshire
Clutch Pressure Plate
I did my first ever clutch change recently. Followed some instructions on the club8090 wiki and i really didn't find it that bad/hard at all.
My question is regarding the pressure plate. Is there more than one way to position it on the dowels? My gearbox/input shaft aligns and fits fine. I just wanted to make sure i haven't messed the pressure plate position up?
Cheers.
My question is regarding the pressure plate. Is there more than one way to position it on the dowels? My gearbox/input shaft aligns and fits fine. I just wanted to make sure i haven't messed the pressure plate position up?
Cheers.
1984 Autosleeper, pop-top, 1.9 1Y, 5-Speed
-
Aidan
- Trader
- Posts: 7028
- Joined: 11 Oct 2005, 19:21
- 80-90 Mem No: 742
- Location: Llanfyllin, mid Wales : )
- Contact:
Re: Clutch Pressure Plate
diesel one only fits in one position so the timing mark is in the right place
-
The Hairy Camper
- Registered user
- Posts: 399
- Joined: 03 May 2017, 00:19
- 80-90 Mem No: 16820
- Location: Cheshire
