Club 80-90 Forums

im going to fit some new fixed quarter light rubber , so i had a quick look yesterday and it would seem that some lube maybe required ? 

id be...

Hi Guys
Anyone fitted a roof vent to a Holdsworth Villa 3 Poptop?
If so what did you buy?
Cheers!
Pete
1990 T25 Holdsworth Villa 3 Poptop.

I’ve read the wiki and checked my fan is working. Both speeds kick in and out with the use of the paper clip so all seems to be ok. However, the...

Has anyone used car seat covers for self fitting from 'car seat covers direct' or similar companies. Also how difficult is it to fit these?
 

Hi. My engine seems to have acquired the habit of over revving when it’s hot. I can drive along the motorway at 60 happily but if I depress the...

As per other post - I am watching closely a starting when hot / stalling issue on my bus.  (T25 1985 DG 1.9).  I'm only changing one thing at a time,...

After a bit of a to do trying to source some repair kits for my early Teves calipers I was informed of this company (about 5 mins from my door :roll:...

Morning,

With the recent epic rain I have water pouring (well very fast drip) in through the pop top skylight;
Looks like it is coming in between...

Hi
 Removed and replaced window scraper on passenger window no problems - lift out / drop in - no clips.
On drivers side new one lifted out (no...

What is the best paint to use for small touch up areas, cellulose or acrylic? 

Hi, looking for recommendations for a gearbox specialist in or near Newcastle upon Tyne. T25 currently stuck at works car park, in Gateshead. Was...

Hi

Looking for a good reliable VW garage in Nottinghamshire that knows air-cooled engines... Can be anyone recommend?

Best

Jon

Hello

I know that lots of peeps have swapped for new seats so can you share pics for inspiration please? My original seats have been covered by my...

1.6 JX 14’ Syncro

hi everyone,

does anyone know if there is supposed to be a gasket between the inboard CV (driveshaft) and the drive flange on the...

Ok, my turn to ask .......

one of our fleet has a Early early water system , very early , the header tank is the old bayonet cap type .
petrol ,...

Factory Central locking locks but won't unlock atleast it will but could be hours or days later. Ferry on Sunday and a little concerned may be locked...

Anyone got a guide? Pretty simple or a ball,ache?
ta
steve 

Hi

Can anyone please tell me the difference between Brake Servo Part No 252612101 and 252612101 A

Both are made by VAG and they look exactly the...

I am converting my panel van to a factory central locking set up. I have make a loom as per the factory colours and bought everything via brickwerks...

Is it possible to adjust the clearance on a sportscraft seat swivel?

There is a big nut but unsure if loosening this will do the trick and still be...

Any advice on the initial setting to start adjusting carburation setting on a pair of drla 36 on a rebuilt 2 liter cu?
I found quite different...

Hi, I’m currently (or about to start) looking for a 15” inch Steel wheel for use as a spare.
I currently have 4x15” Mefro steel wheels on my camper....

I have a remote oil filter & cooler setup I’m fitting to my 1.9 DG.

As the remote housing has a 1/8” npt port I thought I’d add a temperature sensor...

So just 10km from home after doing about 500km of the wild Atlantic way and a sudden metal sounding bang clatter started.

I looked at the oil...

Hi All

Been having a bad missfire for a couple of days getting slowly worse every trip.

only just got home today and had to bail on a trip out....

hi just wired up  my water pumpto sink in my t25 auto sleeper pump running ok but no water making lots hissing noise  turned of at switch  turned...

Hi all,

I'm changing the pilot bearing at the moment and have removed the clutch h to get at it. As I haven't seen a new clutch, I'm not sure how...

Hi all
roll pins in the opening arms has anyone replaced them if so where from and the correct size would be nice thanks :ok

Hi and thanks in advance for your reply.
My bus is a caravelle hightop with cut back on end with struts and luggage bar. The top windows are fixed...

Hi
Two reasons to refurb the insulation..
1. It’s looks tatty
2. As I have an lpg conversion the clearance between the top of the air intake on the...

Hi All

Had a small leak for a while and have tracked it down to this breather pipe. It’s soaked through after driving and a small amount of excess...

I have a burned out rear wiper motor + worm gear & am looking for a replacement.
The VW part No is 251 955 713A.
Whilst looking for one I came across...

Decided to resto the tank, it came up well after media blasting, however has some slight pitting around the feet, so question is, can you use a rust...

We have an Electrolux RM123E fridge (3 way) in our T25 Autohomes Kamper which we would like to replace. Can anyone recommend a fridge that will just...

anyone know of a supplier of the ginge gaskets tailgate side not body side (as already have these)

they a sort of foam material . or does anyone...

First trip out in 14 years, Dehler WBX originally 2.0 lite Oettinger though replaced with DJ driving down a motorway, temperature gauge falling...

Hi has anyone refurbed there engine tray/painted mines in bad order with holes and no sound deadening.what have people used brick werks are out of...

Hello
I just bought a TD club joker high top that needs some care....even though fully drivable.
One among other issues : the upper bed board that is...

Does anyone know where the power feed for the interior lights should come from in a Dehler Profi 2+2 1987 please?
Have power to the central interior...

Hello fellow lockdownees, new member here and my first post :D recently acquired my 1987 T25 Autosleeper 1.9 petrol automatic which runs and drives...

Hi all,

I've just bought my first T25 and whilst it appears mostly solid there are a few little bits on the body work (small bit of seam rash and...

Hi, I have been thinking of fitting an external bbq gas point but definately wont be cutting a hole in any panel, has anyone done this? what fitting...

1989 2.1 DJ Auto PAS.
Manual says remove steering rack first. :roll:

Q1. Anyone changed them whilst rack still on chassis?
Q2. Are they threaded...

I had a really good cab light with two scrolling reading lights as well as a central light, but sadly it has hit the grave. I can't seem to find a...

Hi,

Bought an air hiking mat similar to this one a few years ago to make the pop top mattress more comfortable:

onclick=...

So the truck has been laid up for about a month having a bit of rare TLC. Started it up to get the oil moving prior to an oil change and let it idle...

I've been meaning to ask folk that have poptop leisuredrive conversions and how your hinges are on your roof. Mine are riveted to the roof plus they...

Hi all, as per title, the sliding door on my 1998 caravell drops at the right hand side when closed leaving an uneven gap I can close this gap by...