Club 80-90 Forums

Does this help? Scroll down the page

http://www.justkampers.com/forum2/viewt ... 5&t=167757

So will ordinary car radiator hose not do if you can get the correct length and diameter?
I remember a couple of rear engined cars way back that used standard reinforced rad hose.

I've used this and similar several times to repair small holes in an exhaust. On me van I've only used it to repair a small section that is like a heat shield for the air intake and its been fine. I've also used it in the past to repair small damage to a petrol tank. All in, bloody good stuff, but c...

This does seem to be a major issue, surely the pipes should be fit and go????

Bugger!! Didnt think of that, so undo, twist should do it?

Well heres a one! Last MOT my van failed on 3 flexi brake pipes, a front one and both rear. I bought a complete set from BW, and it passed the MOT Today, it failed MOT on a couple of bits, AND the tester reckons the front flexi pipes are too long and will catch/rub. But they are they correct pipes, ...

This is why I love gaffa tape!

Give it a good tap with a hammer, I put an old socket over it so as not to damage the speedo cable end or circlip. If it still comes off, try "adjusting" the shape of the cover a bit (large hammer), make it a tiny bit oval, then tap it on

Cruz wrote:Was it easy to replace?

about an hour, had to take the thermostat housing off as theres not enough room to squeeze the new pipe in, then low and behold, snapped the outlet pipe on the dalek cap when I went to top the header tank up!
Only replaced it about 4 months ago, bugger, another £15!!

When I noticed this on one of my locks it turned out that someone had removed all the tumblers from the barrel, remove one and have a look

Cruz wrote:Was it easy to replace?

Dunno, just ordered it last night, will report back when done

Sorted.
Incase anyone else gets stuck, Michael at Brickwerks pointed me to this which will fit

http://www.brickwerks.co.uk/index.php?o ... 1&Itemid=3

Heck, if thats from a new tank you must be filling up from somewhere with alot of crap in their storage tanks

Mines on the sloping bit, offset towards the sliding door a bit, and the exhaust protrudes nicely just infront of the jacking point, with the intake pointing in the opposite direction. Hot air duct is out of centre of the front panel of the R&R bed/seat.

"Elvis", member on here and the 'Yard does soda blasting