Club 80-90 Forums

It's a bit tricky taking photos of them without the van being lifted quite a bit unfortunately! Next time I am under it I will have a try. Unless anyone else has pics please?

Thanks. I'll try that when I have refitted it and started her up. Hopefully all will be good!

They are the left and right bits. Obviously I need to replace them then!

Thanks for the info. Very helpful as usual.

1.9 DG Watercooled auto sleeper "Trooper" 1989.

I have two pieces of tinware under the engine, one of which has rusted away quite badly.

Do they need to be there, being watercooled? If so, what are they for?

The smaller rubber rings I believe are for the mixture needles. If you undo them and take them out you should see them. Turn them in first and count how many turns before fully seated before taking out though and do the reverse when refitting. The larger ring is a seal between the water manifold an...

Ah......... Better put it back then!

Thanks for the info. Good job I asked!

I have my carb off for general cleaning and fitting refurb kit. but I have a couple of problems I hope someone can please help me with? Info: 1989 1.9 DG Pierburg SE3 On the Choke pull down diaphragm pipe, I could not blow or suck through it, even when taken off completely! I found it had a small br...

I can't get over how helpful everyone is in this forum! The help I have received regarding this problem with the dash circuit has been truly wonderful. Being a T25 owner, I am delighted and proud to be associated with such nice people. I'll certainly know where to go and who to ask when I have my ne...

Thanks for your reply to my question. Some of it went over my head, but I understood most of it!:-) I quite like the idea of using a computer connector (Maplins).

Hi everyone. I am very new to this board (so please be gentle with me!), but not to VW campers I'm happy to say! :-) My father had a splitty (great childhood holiday memories!), I had a tin top Bay about 10 years back (wish I had never sold it!) and my son has a bay. Just over a week ago I became th...