Difference between revisions of "VW Electrics Diesel battery to starter cable"
Hacksawbob (talk | contribs) (Created page with ''''Hacksawbob''' OK I got a 25mm square section 1 Meter long. The original is a shade shorter than this 95cm probably but the little bit extra gives you routing possibilities, a…') |
Hacksawbob (talk | contribs) |
||
Line 9: | Line 9: | ||
http://www.vehicle-wiring-products.eu/VWP-onlinestore/cable/batterycable.php | http://www.vehicle-wiring-products.eu/VWP-onlinestore/cable/batterycable.php | ||
Battery clamp | Battery clamp Ref: 39901 | ||
http://www.vehicle-wiring-products.eu/VWP-onlinestore/battconns/battclamps.php | http://www.vehicle-wiring-products.eu/VWP-onlinestore/battconns/battclamps.php | ||
Revision as of 10:05, 16 November 2011
Hacksawbob
OK I got a 25mm square section 1 Meter long. The original is a shade shorter than this 95cm probably but the little bit extra gives you routing possibilities, any longer it would cost more and start rubbing against things. I secured against the top of the battery tray where there is a hole in the metal, I twisted a cable tie so it was in a figure 8 (to stop it rubbing against the metal edge. Then over the power steering pump and secured to the bundle of wires at the back of the engine bay. I Reused the rubber boot from the original cable 10mm ring connector crimped on by proper old school motor factors, and a standard battery post terminal Cost £12.95
These would have done it.
Cable is ref 196
http://www.vehicle-wiring-products.eu/VWP-onlinestore/cable/batterycable.php
Battery clamp Ref: 39901 http://www.vehicle-wiring-products.eu/VWP-onlinestore/battconns/battclamps.php
and butt connector for the starter end CTT10 you could probably crimp this in a vice or ask to get them to do it before sending
http://www.vehicle-wiring-products.eu/VWP-onlinestore/battconns/batttermls.php#butt