Difference between revisions of "Brakes brake pipe parts"
Hacksawbob (talk | contribs) |
Hacksawbob (talk | contribs) |
||
| Line 16: | Line 16: | ||
'''Simon Baxter''' on brake pipe over trailing arm. I always cut rears to 525mm for 2WD and syncro | '''Simon Baxter''' on brake pipe over trailing arm. I always cut rears to 525mm for 2WD and syncro. Ignore ETKA also, some are correct, some aren't, your better just copying the originals. | ||
I usually just cut them (don't bother undoing, it takes too long) then use the old pipe as a guide for length, flare them then use a brake pipe bending tool and the old pipe to get the shape of the pipe before I fit it, they practically fall on then and look neat too. | |||
Revision as of 22:50, 19 April 2011
Ian Hulley from busgoons
3/16" O.D. Short Male Nut M10 x 1mm (guide price ~ 24p)
3/16" O.D. Female Nut M10 x 1mm (guide price ~ 17p)
3/16" O.D. Female Connector M10 x 1mm (guide price ~ 80p)
3/16" O.D. Kunifer Brake Pipe (guide price ~ 95p/Mtr.)All the pipes I have come across are
single-flared,unless you know differently
can buy the lot made up from JK just shy of £100 though! http://www.justkampers.com/shop/type_25/copper-brake-pipe-set-right-hand-drive-j16899.html
Simon Baxter on brake pipe over trailing arm. I always cut rears to 525mm for 2WD and syncro. Ignore ETKA also, some are correct, some aren't, your better just copying the originals.
I usually just cut them (don't bother undoing, it takes too long) then use the old pipe as a guide for length, flare them then use a brake pipe bending tool and the old pipe to get the shape of the pipe before I fit it, they practically fall on then and look neat too.
